Notes from the Strategic Operations Bunker
Attention Casters: We are sharing our good fortune with the casting community in our offering of our stock lead alloy. We sell this wonderful low-flux 6% antimonial/2% tin alloy in 16 or 66 lb. lots shipped flat-rate. Take a look by clicking here.
Hi-Tek 2-Extreme Coating: We are now offering our bullets with the Hi-Tek 2-Extreme Coating. The coating is made in Australia and imported here.
We are currently lined to up distribute this coating along with unsized/unlubed bullets so that folks can apply the coating themselves.
The coating itself consists of a catalyst which binds a polymeric colorant agent with acetone which is then applied in bulk to raw bullets and baked onto the bullets' surface at nearly 400 degrees. The coating is a polymer (bonded with metal) and forms an extremely tough new surface for the bullet. The application of the coating is repeated for an additional coat. The bullets are then sized normally but not lubricated, as the coating itself acts as bullet lube. Nominal bullet diameter is not affected.